Table of Contents
Advertisement
Start Your Installation
Connecting the Display (Figure 1.0)
To configure the monitor, please refer to the following figure and procedures.
1. Be sure the computer or video source is turned off.
2. Connect the 12V DC power(1.0). During initial turn on with no video applied, the display will
automatically power on with a self test pattern displayed. The self test pattern consists of
alternating screens of black, white, red, green, and blue.
3. Connect the video signal from your signal source to the video input connector of your choice
and tighten.
4. If needed, connect the external dimming cable connector and audio connectors(1.0). See
details in the Brightness Control section of this document.
5. Turn on your computer or video source.
NOTE: Once video is applied, self test mode is automatically cancelled and will no longer function
when video is removed.
NOTE: To optimize your image, please configure the display mode of your graphic card for a
1280 x 1024 resolution and a 75Hz refresh rate.
Figure 1.0
10
LC17 and LC19 User's Guide
(020-0599-00B)
Advertisement
Table of Contents
