Position The Stove; Chimney Connection - Jøtul F 370 Installation And Operating Instructions Manual

Jøtul F 370 US/CAN 10036803_P14

5.5 Position the Stove

1. Use the clearance diagrams and associated flue collar
connection center-line dimensions to determine
the stove location appropriate to the clearance
requirements specific to your installation. See fig, 8
Measure carefully and position the stove flue collar at
the center-line convergence.
Double-check flue collar alignment with chimney
connections at the wall thimble or chimney ceiling
support adaptor.
5.6 Chimney Connector Installation
5.6.1 Top-exit Orientation
1. Replace the Top Plate.
2. Attach the crimped end of the first section of chimney
connector to the Flue Outlet Adapter with sheet metal
screws. Push the Outlet Adaptor fully into the flue
collar. Fig. 16.
3. From inside the firebox, engage the locking rod through
the tabs on the adaptor and secure it with the cotter
pin.
4. Slide the Air Outlet Grille over the stove pipe into
position on the Top Plate.
5. Re-check stove clearances to combustible materials and
adjust the stove position as necessary.
6. Check stove level and plumb and adjust the leveling
pads as appropriate.
5.6.2 Rear-exit Orientation
1. From inside the firebox, remove the rear Outlet Cover
Plate with removal of the two M8 x 20 mm bolts. Fig. 17.
2. Remove the Flue Collar from the top plate and re-install it
in the rear outlet position inside the firebox. Fig. 17.
3. Attach the crimped end of the first section of chimney
connector to the Flue Outlet Adapter with four sheet
metal screws. Push the Flue Outlet Adaptor into the
flue collar from outside the stove. From inside the stove,
insert the bent end of the locking rod through one of
the tabs, then slide the other end into the opposite tab.
Secure the rod with the cotter pin.
4. Re-install the Flue Outlet Cover Plate over the top outlet
inside the firebox.
5. Replace the Top Plate, Air Outlet Grille, and decorative
Flue Outlet Cover Plate.
14
Air Outlet
Grille
Locking Rod
Cotter Pin
Figure 16. Installing the Outlet Adaptor and Flue Collar
Grille.
Flue Outlet
Cover Plate
Flue Collar
Figure 17.
Outlet Cover Plate and Flue Collar.
Flue Outlet
Adaptor