Table of Contents
Advertisement
Bandsaw Trouble Shooting/ Accessories
Trouble Shooting
Bandsaws are relatively simple machines and with all
machinery regular servicing (preventative maintenance) is
essential to get the best from your saw.
'My bandsaw
won't cut
straight"
"My bandasw
slows down
when cutting"
"My bandsaw
vibrates"
"Can I cut steel
on my
bandsaw?"
• This is the most common question
that you will get from bandsaw
users. Usually the answer lies within
the blade; poor quality blades with
uneven set, the blade is blunt or
damaged often only on one side, the
tooth count is far too high for the
material being cut -remember 2 teeth
minimum and 10 teeth maximum in
the workpiece.
• The fence is out of line with the blade.
• Check drive belt is tensioned
correctly.
• If cutting hard or wet material slow
your feed rate down.
• Check blade is sharp and not too fine.
• Make sure that when curve cutting a
narrow blade is used- see unit 5 blade
and cutter types.
• Clean machine wheels.
• Check blade is running correctly on
wheels.
• Check blade weld – is it in line?
• Check machine is not on an uneven
floor.
• No , most woodcutting bandsaws run
far too fast to cut steel even if a metal
cutting blade is fitted.
Accessories
Below is the list of top recommended accessories and
up-sell items for the bandsaw. Please visit our website at
axminster.co.uk
36
Axminster
Machine
Maintenance
Kit
Lubricants and
maintenance
tools
Bandsaw
Blades
Squares
Cyclone
Extractors
Advertisement
Table of Contents
