Axminster SBW-3501H3 Instructions Manual page 33

Monthly
• Open the lower and upper door and check the condition
of the tyres and the drive belt. Clean out all saw dust and
impacted 'crud' from the wheels and compartment area.
• Apply a little oil to the screw threads of the blade and drive
belt tensioners. DO NOT TO GET ANY OIL ON THE TYRES
AND DRIVE BELT.
• Check the condition of the tyres (A)
• Check the blade for missing teeth and cracks (B)
• Check the condition of the upper/lower blade guides and
thrust bearings and clean any impacted 'crud' from the
bearings using a soft brush, eg. paint brush then spray dry
lubricant, (Axcaliber Dy Lubricant) on the bearing to prevent
resin build up.
NOTE: The guide and thrust bearing should turn freely
when the bandsaw is in use. If the bearings are stiff, clean
them as mentioned above. If this still does not rectify
the problem the bearings are worn and will need to
bereplaced.
• The pivots and the slides of the top wheel mounting
assembly, captive stub axle of the belt tensioner could
likewise be lightly oiled.
• Over time the drive belt can slacken, if adjustment is required
loosen the motor locking handle (C) and press down the
motor assembly handle (D) until the belt is under tension.
Re-tighten the locking handle to secure the motor in position,
see fig 105-106.
• Using an 'M Class' Vaccum cleaner, clean the motor vents
and casing.
• Formulated to minimise wear and reduce
corrosion
• Dry PTFE based lubricating film 400ml
• Unaffected by water, oil or solvents
Will not attract dust
Code: 503468
A
B
D
C
33
Routing Maintenance
Fig 103-104-105-106