Table of Contents
Advertisement
CAUTION!
NEVER OPERATE SAW WITHOUT BLADE
GUARDS IN PLACE.
Vise Operation
Do not make any adjustments or load/unload
material from vise while machine is running!
Failure to comply may cause serious injury!
The vise is mounted on the machine base. Follow
the easy steps to open or close the vise.
1.
Turn the handle (A) Fig.10 counter clockwise to
open the vise jaw to allow the width of vise can
load work piece.
2.
Make sure the work piece is well located on the
table. Turn the handle (A) clockwise to close
the vise jaw to clamp the work piece.
A
Adjusting Blade Tension
Disconnect machine from the power source!
Blades are sharp! Use extra care when
removing, installing or adjusting!
Failure to comply may cause serious injury!
Blade tension is important to the proper operation of
the saw. This saw proper blade tension is in 1100
2
to 1500kg/cm
as measured on blade tension
gauge.
B A
Fig. 9
WARNING
Fig. 10
WARNING
To set the blade tension without the use of a
blade tension gauge:
1.
Disconnect machine power, open wheel covers
to install blade belt between wheels and insert
blade between bearings on blade guides.
2.
Tension blade slightly to remove any sag in
blade between blade wheels.
3.
Turn blade tension knob (A, Fig. 11) clockwise
to tighten until the red line approach to central
line (B, Fig. 11).
4.
After blade has been completely installed,
close wheel covers, connect to the power
source, and run saw for one minute so blade
can seat properly.
Do not over tighten blade. This may cause
blade to stretch and warp.
A
Changing Blades
Never operate this saw unless all blade guards
are installed and in proper working order!
Never adjust blade brush while machine is
running.
Failure to comply may cause serious injury!
CAUTION!
This machine is designed and intended for use
with blades that are 19mm width, 0.9mm
thickness and 2285mm length. Use of blades
with different specification may cause inferior
performance.
1.
Disconnect machine from the power source.
2.
Raise saw bow to proper position and lock in
place by turning hydraulic valve switch off.
3.
Remove saw bow cover (A, Fig. 12) by
removing six screws (B).
4.
Loose blade guard nuts and screws (C, Fig.
13). Remove right and left two blade guards.
5.
Loosen blade tension by turning blade tension
knob (D) counter-clockwise.
4
CAUTION !
B
Fig. 11
WARNING
Advertisement
Table of Contents
