Table of Contents
Advertisement
Available languages
Available languages
cooling performance
•
Before connecting the appliance to the mains and before using it, clean it carefully as indicated under "Cleaning".
•
Before connecting the appliance, make sure that a shockproof socket (with earth) and a 230 volt connection are
available and that this corresponds to the information on the type plate. Other types of current than specified on the
type plate may cause the appliance to overheat or become defective.
•
Do not drill or pierce holes in the inside or outside of the unit. The cooling circuit could be damaged.
•
During the period of use, daily cleaning is recommended for hygienic reasons.
•
Before cleaning, always disconnect the appliance from the mains, switch it off beforehand if it has an on/off switch or a
corresponding control (thermostat) with a zero or off function; the same applies if the appliance is not used for a longer
period of time.
•
The manufacturer/dealer cannot be held responsible for damage caused by failure to observe the operating
instructions. Likewise, the safety of the unit is no longer guaranteed.
•
In the event of a malfunction, disconnect the appliance from the mains and inform your dealer. He will carry out the
repair with original spare parts.
SAFETY INSTRUCTIONS
•
Incorrect operation and improper handling can lead to malfunctions of the unit and injury to the user.
•
The appliance is neither suitable nor intended for the storage of medicines or highly flammable, combustible or
explosive substances.
•
Observe the accident prevention regulations and general safety regulations applicable to the area of use.
•
Ensure that the unit stands securely on a dry, non-slip surface that is adequate for the weight of the unit and that it is in
a well-ventilated place.
•
Do not expose the appliance to direct sunlight, do not place it near other heat sources (heater, cooker, oven... open fire)
and/or do not place it on a hot surface, otherwise the desired cooling capacity cannot be achieved.
•
Do not store highly flammable or explosive substances near the unit.
Do not carry out any work with highly flammable substances in the vicinity of the unit (no spray paint or similar). It could
otherwise lead to a fire or explosion.
•
The unit requires sufficient space for air circulation and cooling pipe: 10 cm each to the sides and to the wall.
•
Do not place heavy objects, loads or liquids on the unit.
•
Make sure that the air inlet and exhaust openings of the appliance are always free of dirt. Check them regularly and
remove any dust deposits using a hoover.
Do not cover or block the air openings.
•
Do not tilt the unit more than 45 degrees.
•
Before connecting to your mains, check that the type of current and mains voltage correspond to the specifications on
the type plate. Commissioning is only possible if they match in order to avoid accidents/defects.
•
Do not use adapters, power strips and/or extension cords; otherwise the cables/cords can quickly overheat if other
appliances are also connected. The risk of fire increases.
•
Do not move the unit during use.
•
Before moving the unit, switch it off (if there is a switch for this purpose) and disconnect the mains plug.
•
Always pull the cable out of the socket by the plug housing only.
•
Make sure that the unit does not tilt when moving. This could lead to injuries.
•
When the unit is back in place, wait 2 hours before operating the unit again.
•
A longer transport causes a standstill time of approx. 24 hours before commissioning in order to avoid unit
damage/accidents as a precaution.
•
After a possible power failure or a short unplugging, switch off the unit briefly, wait 5 minutes, plug in again and start the
unit.
•
Do not let the mains cable hang over sharp edges, do not crush it and keep it away from hot objects and open flames.
•
Make sure that it is not possible to accidentally pull on the cable or trip over it.
•
Check the cable regularly. If it is damaged, e.g. by crushing, then it must be replaced by a qualified specialist.
•
Do not touch the appliance, cable or plug with wet or damp hands.
•
Caution! The unit is live as long as it is connected to the mains.
•
Protect the unit from moisture.
•
Do not clean the appliance with an open jet of water.
•
Do not immerse the unit in water or other liquids or wet it with liquids.
If the appliance should get wet, unplug it from the mains immediately and have it checked by a specialist before using it
again. There is a danger to life from electric shock.
•
A damaged unit must not be used!
Stand 05/23 SvN
Seite 18 von 25
Advertisement
Chapters
Table of Contents
