Danfoss iC7 Series Installation Manual page 12

In-back/Out-back Cooling Kit for FA09-FA10
Installation Guide
1 Top gasket
2 Front gasket
3 M5 nut
4 Front cover
5 Grill gasket
2.8 Installing the Lower Duct
To attach the lower duct to the frequency converter, use the following steps.
Procedure
1.
Place the strip gasket over the 2 slots at the bottom back of the frequency converter.
2. Remove the cover and gasket from the bottom of the frequency converter by removing 7 screws.
Retain the screws, but discard the cover and gasket.
3. Secure the top flange of the duct to the bottom of the frequency converter using the screws removed in step 2.
Refer to Illustration
4. Attach the front duct cover.
12 | Danfoss A/S © 2022.03
10. Torque screws to 2.3 Nm (20 in-lb).
6 Back grill
7 Side gaskets, left and right
8 Duct frame
9 Base gasket
10 Duct base cover
AN371942471353en-000101 / 136R0248
Installation