Danfoss iC7 Series Installation Manual page 5
In-back/out-back cooling kit for fa09-fa10, frequency converters
Hide thumbs
Also See for iC7 Series:
- Application manual (382 pages) ,
- Design manual (150 pages) ,
- Operating manual (64 pages)
Table of Contents
Advertisement
In-back/Out-back Cooling Kit for FA09-FA10
Installation Guide
2.3 Preparing the Mounting Plate
To create mounting holes and vent holes in the mounting plate, use the following steps. Refer to
converters, and
Illustration 4
Procedure
1.
Drill 4 mounting holes in the mounting plate using the dimensions in the FA09 or FA10 template.
The holes must match the holes in the frequency converter.
2.
Insert 4 M10 pem studs (not supplied) in the mounting holes.
3.
Cut out the 2 vent openings in the mounting plate using the dimensions in the FA09 or FA10 template.
The openings must match the upper and lower duct openings.
2x Ø 8 (0.3)
Mounting Holes
130 (5.1)
844 (33.2)
699 (27.5)
140 (5.5)
4x Ø 5 (0.2)
Illustration 3: FA09 Mounting Plate Template for In-back/Out-back Cooling
Danfoss A/S © 2022.03
for FA10 frequency converters.
214 (8.4)
180 (7.1)
7 (0.3)
78 (3.1)
7 (0.3)
122 (4.8)
200 (7.9)
214 (8.4)
228 (9.0)
122 (4.8)
68 (2.7)
10 (0.4)
78 (3.1)
6x Ø 8 (0.3)
2x Ø 8 (0.3)
Mounting Holes
177 (7.0)
Installation
Illustration 3
for FA09 frequency
110 (4.3)
AN371942471353en-000101 / 136R0248 | 5
Advertisement
Table of Contents
