Table of Contents
Advertisement
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Tip: If a meal does not turn out exactly as you wanted,
refer to the "Tested for you in our cooking studio"
section.Here, you will find plenty of cooking tips and
notes.
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
Fault
The appliance does not work
After switching on an operating mode,
a message is shown on the display
which indicates that the temperature
is too high
The appliance cannot be switched on;
the
1
symbol is shown on the dis-
play
The appliance cannot be operated
when it is switched on; the
1
bol is shown on the display
The appliance does not heat up;
is shown on the display
The appliance door cannot be
opened; the
5
symbol is shown on
the display
"D" or "E" appears on the display, e.g.
D0111 or E0111
Home Connect does not work cor-
rectly.
--------
Maximum operating time exceeded
Your appliance ends the operation automatically when
no cooking time is set and the setting has not been
changed for a long time.
The actual cooking time until the operation is stopped
automatically varies according to the selected settings.
The appliance display indicates that the operation will
end automatically. Afterwards, the operation is stopped.
Possible cause
The plug is not plugged into the mains
Power cut
The circuit breaker is faulty
The appliance has not cooled down sufficiently
The automatic childproof lock is activated
The childproof lock is activated
sym-
Demo mode is activated in the basic settings
6
The appliance door is locked until the cooking com-
partment has cooled down
The childproof lock locks the appliance door
Technical problem
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
:
Warning – Risk of electric shock!
Work on the appliance electronics may only be
■
performed by a specialist.
Always disconnect the appliance from the power
■
supply when work is carried out on the electronics.
Switch off the circuit breaker or remove the fuse
from your household fuse box.
Notes/remedy
Connect the appliance to the power supply
Check whether other kitchen appliances are working
Check in the fuse box to make sure that the fuse for
the appliance is OK
Allow the appliance to cool down and switch the oper-
ating mode on again
Press and hold the
bol goes out
Press and hold the
bol goes out
Disconnect the appliance from the mains for approx.
10 seconds (switch off the circuit breaker in the fuse
box) and then deactivate demo mode in the basic set-
tings within 3 minutes
~ "Basic settings" on page 18
Wait until the
Press and hold the
bol goes out; adjust the childproof lock setting
Switch the appliance off and on again
If the message appears again, call the after-sales ser-
vice. Quote the exact error message
Go to www.home-connect.com
To use the appliance again, switch it off beforehand.
Then switch the appliance on again and set the
required operation.
Trouble shooting
0
touch button until the
0
touch button until the
5
symbol goes out
0
touch button until the
en
1
sym-
1
sym-
5
sym-
29
Advertisement
Table of Contents
