Table of Contents
Advertisement
Trouble shooting
en
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
■
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
The hinges on the appliance door move when
Risk of injury!
■
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Fitting the door panels on the appliance
When fitting the intermediate panel, make sure that the
arrow is in the top right of the panel and that it aligns
with the arrow on the metal panel.
Insert the intermediate panel into the retainer at the
1.
bottom and push it in firmly from the top (fig.
Push both retainers downwards (fig.
2.
Insert the front panel downwards into the retainers
3.
(fig.
).
#
Close the front panel until both upper hooks are
4.
opposite the opening (fig.
Press the front panel down until it clicks audibly into
5.
place (fig.
).
%
Open the appliance door again slightly and remove
6.
the tea towel.
Screw both screws back in on the left and right.
7.
Put the cover back in place and press on it until it
8.
clicks audibly into place (fig.
Fault
The appliance does not work
After switching on an operating mode,
a message is shown on the display
which indicates that the temperature
is too high
28
).
!
).
"
).
$
).
&
Possible cause
The plug is not plugged into the mains
Power cut
The circuit breaker is faulty
The appliance has not cooled down sufficiently
Close the appliance door.
9.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
3Trouble shooting
If a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Tip: If a meal does not turn out exactly as you wanted,
refer to the "Tested for you in our cooking studio"
section.Here, you will find plenty of cooking tips and
notes.
:
Warning
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
:
Warning
Risk of electric shock!
Work on the appliance electronics may only be
■
performed by a specialist.
Always disconnect the appliance from the power
■
supply when work is carried out on the electronics.
Switch off the circuit breaker or remove the fuse
from your household fuse box.
Notes/remedy
Connect the appliance to the power supply
Check whether other kitchen appliances are working
Check in the fuse box to make sure that the fuse for
the appliance is OK
Allow the appliance to cool down and switch the oper-
ating mode on again
Advertisement
Table of Contents
