Danfoss iC7 Series Installation Manual page 3

Multiwire Kit for Fx09-Fx10
Installation Guide
c. Align the hole in the lug with the hole in the terminal busbar.
d.
- Check that the lug is in contact with the busbar.
- e. Tighten the cable gland.
1
Illustration 1: Installation of 1
nd
3.
Install the 2 cable:
- a. Attach the lug to the cable.
b.
- Position the lug on top of the terminal busbar.
See Illustration
c.
- Align the hole in the lug with the hole in the terminal busbar.
-
Danfoss A/S © 2022.10
st
Cable
2.
2
AN428032702374en-000101 / 136R0316 | 3
Installation