Operation; Stand Alone Operation; Master/Slave Operation; Control Board - EuroLite LED TMH-4 User Manual

OPERATION

With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the EUROLITE LED TMH-4 Wash starts running. During the
Reset, the motors are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the LED TMH-4 Wash can be used without controller.
Disconnect the LED TMH-4 Wash from the controller and call the internal program. Please refer to the
instructions under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode - „Automatic program mode" or „Sound controlled mode" - for the master-
device. Set the DMX address 1 for all slave-devices.

Control Board

The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or make a reset.
UP
MODE/ESC
DOWN
ENTER
25/30
The main menu is accessed by pressing the
Mode/Esc-button. Browse through the submenu by
pressing Up or Down. Press the Enter-button in
order to select the desired menu. You can change
the selection by pressing Up or Down. Confirm every
selection by pressing the Enter-button. You can
leave every mode by pressing the Mode/Esc-button.
The functions provided are described in the following
sections.
00048784.DOC, Version 1.1