Table of Contents
Advertisement
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. To adjust the drive belt,
first press the power switch to the off position and
unplug the power cord.
Next, remove the indicated M4 x 16mm Screw (61),
the Left Leg Inner Cover (39), and the Left Leg Outer
Cover (92).
39
101
92
33
33
76
Then, remove the two M8 x 16mm Hex Screws (76)
and the two M8 Washers (33) from the Left Upper
Body Leg (101) and the Left Pedal Arm (14).
Next, remove
the M8 x 14mm
Shoulder Screw
(81) from the Left
Pedal Arm (14),
and remove the
Left Pedal Arm
from the elliptical.
Next, remove the
four M4 x 16mm
Screws (not
shown) from the
Large Storage
61
76
14
81
37
14
36
Foot (27), and remove the Large Storage Foot.
Remove the two M4 x 16mm Screws (not shown) from
the Top Shield (37), and then use a standard screw-
driver to pry the Top Shield upward off the elliptical.
Then, pry the left Pedal Disc (36) off the elliptical.
See EXPLODED DRAWING C on page 27. Identify
the Left and Right Shields (44, 45). Remove all of the
M4 x 16mm Screws (61) and 3/16" x 1 1/2" Screws
(64) from the Left and Right Shields. Make sure to
note which size Screws come from which holes.
Then, carefully remove the Left Shield.
Next, loosen the Idler Screw (97). Tighten the Idler
Adjustment Screw (72) until the Drive Belt (46) is tight,
and then retighten the Idler Screw.
46
72
When you are finished, reattach all of the parts that
you removed. Then, plug in the power cord.
27
21
97
Hide quick links:
Advertisement
Table of Contents
