Setting The Units - AND PREMIUM UC-352CNBLE Instruction Manual

Connecting to a mobile device (Pairing)
• Turn the power of other Bluetooth
• If measurement data cannot be received, try pairing again. After pairing is
complete, all communications are done automatically if the receiver is in the
receivable state.
• In the unlikely event that this scale causes radio wave interference to
another wireless station, either change the location where the scale is used
or stop using the scale immediately.

Setting the Units

1. Confirm that the scale is turned off, and press the set switch.
2. Press the set switch to select the unit that you want to set.
• The unit changes each time the set switch is pressed.
• Wait for 3 seconds after setting the unit.
3. Confirm that "End" is displayed.
• The settings are saved.
• After three seconds of non-operation, the scale
confirms the selected unit with two beeps, displays
"End " and automatically turns off.
4. If you to wish to delete any readings stored in memory
press the set switch. Changing the units format will delete
any stored readings on the scale.
selected unit with two beeps, displays "End " and automatically
Note: To see readings stored in memory they must be transferred to your
mobile device and displayed in the app.
Caution for Pairing
devices off when performing pairing.
®
E-10
Beep
lb
lb
kg
Beep beep