Advertisement
Available languages
Available languages
For the operation of the core drill, its operating instructions and safety
advices have to be strictly observed!
Unlocking the carriage:
1
In order to operate the tool safely, please observe the following notes:
Details of the work area
Keep the work area free of everything which could obstruct operations.
Provide for adequate illumination of the work area.
Adhere to the regulations concerning the power connection.
Lay the power cable in such a way that any damage by the drill can be avoided.
The tool is supplied with a mounting plate,
a 10 mm fitting key and 8 Allen screws.
The mounting plate is put on in such a way with the
fitting key on the machine that the socket is in the
mounting plate on the same side as the gear switch
of the machine. Afterwards the four screws are
insert and tightened firmly.
Attention!
From a drill diameter of 350mm must be fitted
the included adapter plate. Use here the 4 long
screws.
Insert the core drill with the attached mounting
plate into the drill rig and lock it with the turnstile .
To unlock the carriage (1) pull out the lock
knob (2).
To lock the carriage move the carriage until
the locking shaft passes the hole in the
2
column and jumps into place.
Always lock the carriage when the
assembly is not in use.
Operations
15
Advertisement
