Startup / Operation - BOMANN KSG 7282.1 Instruction Manual

• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Remove the plastic rivet (1) and hinge cover (2).
• Loosen the screws (3) and remove the door hinge
(4). Lift the unit door from the door hinge (6).
• Displace the dummy plug (5) of the appliance
door. Place the appliance door safely aside.
• Tilt the unit slightly backwards and block it in this
position.
• Disassemble the lower door hinge (6) incl. foot by
loosening the screws (7). Unscrew the separate
foot (8).
• Displace and fasten the door hinge (6) incl. foot
with the screws (7) accordingly. Screw in the sep-
arate foot (8).
screw wrench, Phillips screw-
• Return the unit to the upright position. Place the
appliance door on the hinge pin and fix it in the in-
tended position.
• Displace and fasten the upper door hinge (4) with
the screws (3) accordingly.
• Put the plastic rivet (1) in the exposed hole and
replace the hinge cover (2).
Check that the door is aligned vertically and horizon-
tally to ensure proper opening and closing of the
door.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and maintenance"
the chapter
Starting the appliance
• Connect the appliance to the power supply.
• Set the operating conditions. See also the follow-
ing sections.
Settings
The power levels [ 1 – 5 ] regulate the different val-
ues of the internal temperature.
Power level
lowest level,
1, 2
warmest internal temperature
medium level,
3
recommended operating temperature
19
.