Table of Contents
Advertisement
To Add a Prefix or Suffix
Step 1. Scan the Add Prefix or Add Suffix symbol
Step 2. Determine the 2 digit Hex value from the Symbology Chart (included in
Appendix
suffix. For example, for Code 128, Code ID is "j" and Hex ID is "6A".
Step 3. Scan the 2 hex digits from the
cover of this manual or scan 9, 9 for all symbologies.
Step 4. Determine the hex value from the
1252), page A-3, for the prefix or suffix you wish to enter.
Note: To add the Code I.D., scan 5, C, 8, 0.
To add AIM I.D., scan 5, C, 8, 1.
To add a backslash (\), scan 5, C, 5, C.
To add a backslash (|), you must scan 5C twice – once to create the
leading backslash and then to create the backslash itself.
Step 5. Scan the 2 digit hex value from the
cover of this manual.
Step 6. Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7. Scan Save to exit and save, or scan Discard to exit without saving.
Repeat Steps 1-6 to add a prefix or suffix for another symbology.
Example: Add a Tab Suffix to All Symbologies
Step 1. Scan Add Suffix.
Step 2. Scan 9, 9 from the
manual to apply this suffix to all symbologies.
Step 3. Scan 0, 9 from the
manual. This corresponds with the hex value for a horizontal tab,
shown in the
page A-3.
Step 4. Scan Save, or scan Discard to exit without saving.
To Clear One or All Prefixes or Suffixes
You can clear a single prefix or suffix, or clear all prefixes/suffixes for a symbol-
ogy. When you Clear One Prefix (Suffix), the specific character you select is
deleted from the symbology you want. When you Clear All Prefixes (Suffixes),
all the prefixes or suffixes for a symbology are deleted.
4 - 2
A) for the symbology to which you want to apply the prefix or
Programming Chart
Programming Chart
ASCII Conversion Chart (Code Page 1252),
(page
Programming Chart
ASCII Conversion Chart (Code Page
Programming Chart
inside the back cover of this
inside the back cover of this
4-3).
inside the back
inside the back
beginning on
Advertisement
Table of Contents
Troubleshooting
