Honeywell YOUJIE YJ-HH360 User Manual page 165

Is the scanner having trouble reading your symbols?
If the scanner isn't reading symbols well, check that the symbols:
• Aren't smeared, rough, scratched, or exhibiting voids.
• Aren't coated with frost or water droplets on the surface.
• Are enabled in the scanner or in the decoder to which the scanner connects.
Is the bar code displayed but not entered?
The bar code is displayed on the host device correctly, but you still have to press
a key to enter it (the Enter/Return key or the Tab key, for example).
You need to program a suffix. Programming a suffix enables the scanner to out-
put the bar code data plus the key you need (such as "CR") to enter the data
into your application. Refer to
information.
The scanner won't read your bar code at all.
1. Scan the sample bar codes in the back of this manual. If the scanner reads
the sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see
on page 6-1).
2. If the scanner still can't read the sample bar codes, scan
page 6-2.
If you aren't sure what programming options have been set in the scanner, or if
you want the factory default settings restored, scan
Defaults on page 1-5.
Prefix/Suffix Overview on page 4-1 for further
Symbologies
All Symbologies
Resetting the Custom
beginning
on
11 - 3