SD card reader
Removing SD card reader
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
primary solid-state
4. Remove the
secondary solid-state
5. Remove the battery.
6. Remove the
long CAMM
NOTE:
For models shipped with long CAMM module.
7. Remove the
inner
frame.
About this task
The figure indicates the location of the SD card reader and provides a visual representation of the removal procedure.
Steps
1. Disconnect the SD card reader flat printed cable (FPC) and LED board FFC from their connector on the SD card reader.
2. Remove the (M2x2) screw that secures the SD card reader on the computer chassis.
3. Lift to remove the SD card reader with its FPC out of the computer.
Installing SD card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the SD card reader and provides a visual representation of the installation procedure.
62
Removing and installing components
before working inside your
drive.
drive.
module.
computer.