Yamaha Tracer 9 GT 2021 Manual page 42

Instrument and control functions
BC
BC Setting
BC
5
The brake control system has two set-
tings, BC1 and BC2. Select BC1 when
only standard ABS is desired. Select
BC2 to have the brake control system
further regulate brake pressure while
cornering to suppress lateral wheel
slip.
TIP
For skilled riders and when riding at the
track, due to varying conditions, the
BC2 brake system may engage sooner
than expected relative to your desired
cornering speed or intended cornering
line.
QS
2
MPH
The quick shift system indicators are
divided into QS
QS and QS
can be independently turned on or off.
QS can be set to ON or OFF.
OFF turns the respective upshift or
downshift function off, and the clutch
lever must then be used when shifting
in that direction.
TIP
If the QSS setting cannot be changed:
turn the engine off with the gear posi-
tion set to neutral, then change the set-
ting.
QS Setting
QS ON
QS ON
MPH
and QS sections.
are not linked and
5-17
"Shift Indicator"
Shift Indicator
IND Mode ON
IND Start 8000 r/min
IND Stop 10000 r/min
This module allows a custom shift indi-
cator to be set. When the engine r/min
(rotations per minute) are in the speci-
fied range, the gear indicator will flash.
This module has 3 options:
"IND Mode" - the shift indicator can be
turned ON/OFF
"IND Start" - the r/min at which the in-
dicator starts flashing can be chosen.
Once selected, rotate the wheel switch
up/down to increase or decrease the
r/min value by increments of 200 r/min.
"IND Start" is settable between 6000 -
12800 r/min.
"IND Stop" - the r/min at which the in-
dicator stops flashing can be chosen.
Once selected, rotate the wheel switch
up/down to increase or decrease the
MPH