Table of Contents
Advertisement
Spin
Start/Pause
TRANSPORT/HANDING
If fault code "F13" is shown
Door lock is abnormal. Start program for 20 sec and unlock the washer door
(PTC) to check whether the door is closed.
Open or close it again.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
If fault code "F14" is shown
Door open fault.
Action: Press "Start/Pause" button. The washing machine will try to open the door.
The alarm will not be removed until the door is unlocked. Or, press the "On/Off"
ELECTRICAL CONNECTION
button to restart the washing machine, and the alarm will be removed.
If fault code "F24" is shown
Water level reaches overflow level.
Remove it by pressing "Start/Pause" key and drain away water.
adequate for the machine's 10 A Current Rating.
Select and start required program. If fault occurs again, disconnect power supply
and contact with after-sale service.
The electrical power cable must be replaced exclusively by a licensed electrician.
If else fault code "F04" to "F98" is shown
Electronic module fails.
Press "Power Supply" key for 3 sec to turn off the machine.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
If fault code "Unb" is shown
Unbalance alarm shall be solved by the following methods.
1.Laundry winding.
Turn the knob to "off" for 3 seconds for shutdown, open the door, shake the
clothes and put them back into the washing machine, then select the single
dewatering program to dry again.
2.Too light-weighted laundry.
Turn the knob to "off" for 3 seconds for shutdown, open the door, put in one or
two towels, and then select the single dewatering program to dry again.
AFTER-SALES SERVICE
18
19
Advertisement
Table of Contents
