3
3.1
3.1.1
w
0312884_SCC_UKUK_V1.0, 2017-10-03
Interface
Operator interface
The operator interface consists of:
•
a control switch (see section 3.1.1) on the left side of the water heater
•
5 push buttons (see section 3.1.2) to navigate through the menu
•
a LCD-display (see section 3.1.3) that shows settings, functions, values and errors.
The operator interface is parameter driven and enables the user to change parameters and
to verify the status and history of the water heater.
Fig. Operator interface
1
Control Switch
With the control switch you can activate and deactivate the controller of the water heater.
Warning
The power of the water heater stays on when the control switch is set to 0.
When the control switch is set to I, the display first shows ini for some seconds. After
that, the display shows OFF.
Fig. Display
1. LCD display
2. Push buttons
2
19