CYBEX 70T Service Manual page 26

RFID Module
Theory of Operation:
The RFID module is used in a Discover console to allow interface to various RFID products (key fobs, cards, etc.). This module is an
optional module and can be ordered with any Discover SE3HD console.
Functions/Connectors:
• The only function of this module is to allow RFID functionality in the Discover console.
• There are some specific connections and routing of cables for the RFID module, and are all described in the documents already
posted to LFTechSupport. Please review documents on
• This RFID module is located in the reading rack of the console. This location was chosen for more reliable (smaller distance)
activations between the RFID module and the customers RFID products.
Troubleshooting tips:
• Retrofit instructions for the RFID module are posted on LFTechSupport. There will soon be updates to include the new installation
location in the reading rack. If there are any issues, first make sure all the steps in the procedure are followed and all the cable
connections are properly made. If issues persist, contact Cybex Customer support for further assistance.
• Retrofit Assembly Instructions RFID Module Discover Non-Treadmill
• Retrofit Assembly Instructions RFID Module Discover Treadmill
• For setup of the RFID see
• There have been some reports of "Audio noise heard in the headphones" when plugged in the headphone plug of the console. This
was isolated to the routing of the RFID cables, specifically the audio wires (twisted pairs to Headphone / USB board) and the power
cable to the RFID module. Those will need to be separated or a ferrite use to negate the noise. See Service Bulletin
console with Audio Noise using headphones
RFID Setup and Verification Guide for Discover Tablet consoles
on LFTechSupport
LFTechSupport (as highlighted below).
for more info.
Page 24 of 116
posted to LFTechSupport.
Discover RFID