Flame And Igniter Rod - Rheem IKONIC RTGH-S11i Manual

HOW TO REMOVE COMPONENTS

FLAME AND IGNITER ROD

1. Remove the hook film part of the Over Heat Limiter
(OHL ). DO NOT cut the film.
2. Remove flame rod and igniter rod wires wire from the
rods.
3. Remove 3 screws from flame rod bracket, and pull
the rod bracket.
Flame Rod
Igniter Rod
69 IKONIC Tankless Water Heater Service Manual
NOTE: When reassembling flame and igniter rods,
please use a spare gasket if the condition of the gasket
is not good.
The spare gasket is located at lower left in the unit.