Water Saving Control; Setting Manifold Heaters - Rheem IKONIC RTGH-S11i Manual

SETTINGS
USER INTERFACE AND OPTIONS
4. The factory setting is "Sea Level" Press the "▼" or
"▲" button to select "Low Altitude", "Med. Altitude"
and "High Altitude", and press "ENTER" to confirm.
BACK ENTER
SETTINGS STATUS SERVICE MODE
SECTION
Sea Level
Low Altitude
Med. Altitude
SET POINT
High Altitude
BACK ENTER
SETTINGS STATUS SERVICE MODE
On
BACK ENTER
SETTINGS STATUS SERVICE MODE

WATER SAVING CONTROL

1. Press the "SETTINGS" button.
2. Press the "▼" or "▲" button until "Tankless Config."
None
is displayed, and press "ENTER" to confirm.
BACK ENTER
SETTINGS STATUS SERVICE MODE
Tankless Config
BACK ENTER
STATUS SERVICE MODE
TANKLESS CONFIG
BACK
SETTINGS STATUS
Sea Level
BACK ENTER
SETTINGS STATUS SERVICE MODE
HIGH-ALTITUDE
Recirc.Pump Mode
BACK ENTER
SETTINGS STATUS SERVICE MODE
0 – 2,000 ft
(0 m – 610 m)
2,001 ft – 5,400 ft
(610 m – 1,650 m)
5401 ft – 7,900 ft
(1,650 m – 2,410 m)
Tankless Config
7,901 ft – 10,200 ft
BACK
SETTINGS
Off
(2,410 m – 3,110 m)
BACK
SETTINGS STATUS
SET POINT
BACK ENTER
SETTINGS STATUS SERVICE MODE
OFF
BACK
SETTINGS STATUS
Tankless Config
BACK ENTER
SETTINGS STATUS SERVICE MODE
BACK
SETTINGS
29
3. Press the "▼" or "▲" button until "Water Saver Mode"
is displayed, and press "ENTER" to confirm.
ENTER
SERVICE MODE
4. The Factory setting is "Off" Press the "▼" or "▲" but-
ton to select "On" and press the "ENTER" button to
confirm. To exit this setting, press "Back".
ENTER
STATUS SERVICE MODE
ENTER
SERVICE MODE
NOTE: Water saving control can reduce waste water at
initiation of hot water demand by reducing flow until
outlet hot water reaches the set temperature.

SETTING MANIFOLD HEATERS

This setting is used to tell the "Manager" (unit with in-
stance number 1) in a series of manifold heaters how
many manifold heaters it will be managing. Refer to the
following steps to set this.
1. Press the "SETTINGS" button.
ENTER
SERVICE MODE
Recirc.Pump Mode
BACK
SETTINGS
ALTITUDE
ENTER
STATUS SERVICE MODE
IKONIC Tankless Water Heater Service Manual
BACK
SETTINGS STATUS SERVICE
Water Saver Mode
BACK
SETTINGS STATUS SERVICE
On
BACK
SETTINGS STATUS SERVICE
Recirc.Pump Mode
BACK
SETTINGS STATUS SERVICE
SET POINT
BACK
SETTINGS STATUS SERVICE
ENTER
STATUS SERVICE MODE
ENTER
MODE
ENTER
MODE
ENTER
MODE
ENTER
MODE
ENTER
MODE
TA
BACK
SETTIN
BACK
SETTINGS