High Altitude Adjustment - Rheem IKONIC RTGH-S11i Manual

IKONIC Tankless Water Heater Service Manual
USER INTERFACE AND OPTIONS
SET POINT
ENTER
STATUS SERVICE MODE
3. Press the "▼" or "▲" button until "Recirc. Pump
Modes" is displayed, and press "ENTER" to confirm.
4. The Factory setting is "None." Press the "▼" or "▲"
button until "Schedule" is displayed, and press "EN-
TER" to confirm. To exit this setting, press "BACK"
button until the Home screen is displayed displayed.
None
ENTER
STATUS SERVICE MODE
SETTINGS
SETTINGS
NOTE: To use this schedule mode, Wi Wi-Fi is required
on this user interface. The specific application should
also be downloaded to your smart phone. Please see
"Wi-Fi Setting" in the U&C manual to set Wi-Fi on this
user interface and to download the application.
Tankless Config
BACK
SETTINGS STATUS
Recirc.Pump Mode
BACK ENTER
SETTINGS STATUS SERVICE MODE
OFF
BACK
SETTINGS STATUS
Schedule
BACK ENTER
STATUS SERVICE MODE
SET POINT
BACK ENTER
STATUS SERVICE MODE
SET POINT
BACK
SETTINGS STATUS
Tankless Config
BACK
SETTINGS STATUS SERVICE
BACK
SETTINGS
28
ENTER
SERVICE MODE
MANUALLY OPERATE
RECIRCULATION PUMP
When set the "Recirc Pump" is set to "ENABLE", the recir-
culation pump is on for 5 minutes or until the return water
temperature reaches approximately 15°F below the set
temperature.
HIGH ALTITUDE
ADJUSTMENT
1. Press the "SETTINGS" button.
ENTER
SERVICE MODE
2. Press the "▼" or "▲" button until "Tankless Config"
is displayed, and press "ENTER" to confirm.
ENTER
SERVICE MODE
3. Press the "▼" or "▲" button until "Elevation" is dis-
played, and press the "ENTER" button.
ENTER
MODE
None
ENTER
STATUS SERVICE MODE
Recirc.Pump Mode
BACK ENTER
SETTINGS STATUS SERVICE MODE
SET POINT
BACK ENTER
SETTINGS STATUS SERVICE MODE
Tankless Config
BACK ENTER
SETTINGS STATUS SERVICE MODE
Elevation
BACK ENTER
SETTINGS STATUS SERVICE MODE
OFF
BACK ENTER
SETTINGS STATUS SERVICE MODE
Re
BAC
SETTI
BACK
SETTING