Basic Operation - Turbo Air TGM-7SD N Series Installation And Operation Manual

BASIC OPERATION (DIGITAL TYPE)
1. Plug in and turn on the power and lamp switch located on the top of the bottom
grille right side. (Except for model "TGF-5SD*-N#")
The display panel will be lighted and make a beep sound.
The compressor will begin to run.
2. The default temperature setting is at 37℉(3℃) for the Chillers.
The default temperature setting is at -8℉(-22℃) for the Freezers.
3. The compressor is automatically cycled by the electronic controller (PCB, F-Sensor).
4. The defrost cycle is automatically controlled by the D-sensor, and the PCB.
5. Push the temperature up(+) button for higher temperatures and the temperature
down(-) button for lower temperatures.
6. Evaporator fan motor will run after all doors are completely closed.
7. Good air flow in freezer is critical.
Be careful to load frozen food stuffs so that it neither presses against the rear wall,
nor reaches within 4inch(10cm) from the evaporator compartment.
13
Turbo air