Wolfspeed SPEEDVAL KIT HALF-BRIDGE MOD-MB-HB-0900V-40A User Manual page 54

contact Wolfspeed for assistance if a board schematic is not included in the Documentation or if users have
questions about a board's components. When operating the board, users should be aware that these
components will be hot and could electrocute or electrically shock the user. As with all electronic
evaluation tools, only qualified personnel knowledgeable in handling electronic performance evaluation,
measurement, and diagnostic tools should use the board.
User Responsibility for Safe Handling and Compliance with Laws
Users should read the Documentation and, specifically, the various hazard descriptions and warnings
contained in the Documentation, prior to handling the board. The Documentation contains important
safety information about voltages and temperatures.
Users assume all responsibility and liability for the proper and safe handling of the board. Users are
responsible for complying with all safety laws, rules, and regulations related to the use of the board. Users
are responsible for (1) establishing protections and safeguards to ensure that a user's use of the board will
not result in any property damage, injury, or death, even if the board should fail to perform as described,
intended, or expected, and (2) ensuring the safety of any activities to be conducted by the user or the user's
employees, affiliates, contractors, representatives, agents, or designees in the use of the board. User
questions regarding the safe usage of the board should be directed to Wolfspeed.
In addition, users are responsible for:
● compliance with all international, national, state, and local laws, rules, and regulations that apply to the
handling or use of the board by a user or the user's employees, affiliates, contractors, representatives,
agents, or designees.
● taking necessary measures, at the user's expense, to correct radio interference if operation of the board
causes interference with radio communications. The board may generate, use, and/or radiate radio
frequency energy, but it has not been tested for compliance within the limits of computing devices
pursuant to Federal Communications Commission or Industry Canada rules, which are designed to provide
protection against radio frequency interference.
● compliance with applicable regulatory or safety compliance or certification standards that may normally
be associated with other products, such as those established by EU Directive 2011/65/EU of the European
Parliament and of the Council on 8 June 2011 about the Restriction of Use of Hazardous Substances (or the
RoHS 2 Directive) and EU Directive 2002/96/EC on Waste Electrical and Electronic Equipment (or WEEE).
The board is not a finished end product and therefore may not meet such standards. Users are also
responsible for properly disposing of a board's components and materials.
No Warranty
THE BOARD IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, INCLUDING BUT NOT LIMITED TO ANY
WARRANTY OF NON-INFRINGEMENT, MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE,
WHETHER EXPRESS OR IMPLIED. THERE IS NO REPRESENTATION THAT OPERATION OF THIS BOARD WILL
BE UNINTERRUPTED OR ERROR FREE.
Limitation of Liability
IN NO EVENT SHALL WOLFSPEED BE LIABLE FOR ANY DAMAGES OF ANY KIND ARISING FROM USE OF
THE BOARD. WOLFSPEED'S AGGREGATE LIABILITY IN DAMAGES OR OTHERWISE SHALL IN NO EVENT
EXCEED THE AMOUNT, IF ANY, RECEIVED BY WOLFSPEED IN EXCHANGE FOR THE BOARD. IN NO EVENT
SHALL WOLFSPEED BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, OR SPECIAL LOSS OR DAMAGES OF
PRD-06829 REV. 1, December 2022
© 2022 Wolfspeed, Inc. All rights reserved. Wolfspeed® and the Wolfstreak logo are registered trademarks and the
SpeedVal Kit™ and Wolfspeed logo is a trademark of Wolfspeed, Inc. Other trademarks, product and company names
are the property of their respective owners and do not imply specific product and/or vendor endorsement,
sponsorship or association.
SpeedVal Kit™ Half-Bridge User Guide
54