Install Wall Bumpers; Remote Alarm Contacts; Install Shelves - Thermo Scientific Forma 900 Series Operating And Maintenance Manual

Section 1
Installation and Start-Up

Install Wall Bumpers

Install Shelves

Remote Alarm Contacts

1-6 Model 900 and 5900 Series
The parts bag, located inside the cabinet, contains the following parts.
Quantity Stock #
2 510016
2 380520
Table 1-1. Parts bag
Install the bolts into the pre-tapped holes on the back of the compressor
section. Install a neoprene cap on each bolt. Refer to Figure 1-2 for the
locations of the pre-tapped holes.
Install the shelf clips into the shelf pilasters (front and back) at the desired
shelf level. Install the shelves in the cabinet onto the clips.
Note Maximum shelf load is 100 lbs (45.4 kg) per shelf.
Note On units having the optional 5 inner door option, refer to the
instructions accompanying the inner door kit.
See Figure 1-2 for the location of the remote alarm contacts. The remote
alarm connector is located in the parts bag provided with the manual. It
must be installed if connecting the freezer to an alarm system. After
installing the wiring from the alarm system to the connector, install the
connector to the freezer microboard and secure with the two screws
provided. The remote alarm provides a NO (normally open) output, a NC
normally closed) output and COM (common). The contacts will trip on a
power outage and high temperature or low temperature alarms. They will
also trip on high stage, control probe or microboard failures.
Figure 1-8 shows the remote contacts in alarm state.
Figure 1-8. Remote Alarm Contacts
Description
1/4-20 x 5-1/2" Bolt
Neoprene Cap
s
IMPORTANT USER INFORMATION IMPORTANT USER INFORMATION
aution! Stored product should be protected
by a redundant 24 hour/day monitoring
system with alarm capability. An interconnect
jack and thermocouple are installed
for centralized monitoring, should on-board
system fail.
Purpose
Wall Bumper
Cap Protector
s
Thermo Scientific