Dometic BSC01 Installation And Operating Manual page 11

CAM1000 / BSC01
8.2 Test indicator when switching on
See fig. a
I
NOTE
The video system switches in stand-by-mode soon as the ignition is switched on. The
system is activated from a speed of less than 40 km/h. The camera image appears. The
red field indicates the active area where detection takes place.
The test indicator allows the camera to be correctly aligned with the front of the vehicle. The
reference line (fig. a 1) shall be at least in alignment with the front of the vehicle. The active area
(fig. a 2) is marked as a red area in the video for 6 seconds.
I
NOTE
In night mode with ambient lighting below 50 lux, the camera switches to black and
white mode. This is necessary to optimize object detection even in poor lighting con-
ditions.
The CAM1000 / BSC01 is automatically activated at a speed of less than 40 km/h.
As soon as objects move in the same direction and faster as the vehicle, the dynamic arrow indica-
tor (fig. b 3) appears in the display. If the audible signal is connected, an evenly repeating beep
will sound.
EN
Using the CAM1000 / BSC01
11