Table of Contents
Advertisement
Treadmill Desk Troubleshooting
Problem: The desktop surface is not level.
Solution: Check to make sure the base feet are on a level surface. Run
calibration by pressing and holding the height
adjustment buttons
simultaneously for three seconds.
Problem: "E32" appears in the display.
Solution: Check to make sure the motor wires from the Left and Right
Motorized Legs are properly connected into the Electronic Control Box. See
page 17. Run calibration by pressing and holding the height
adjustment
buttons simultaneously for three seconds.
Problem: The treadmill belt is beginning to slip and needs to be
tensioned.
Solution: Refer to the owners manual included with the treadmill base.
Problem: The treadmill belt is beginning to drift to the left or right and
needs to be aligned.
Solution: Refer to the owner's manual included with the treadmill base.
Problem: "E26" appears in the display.
Solution: There may be too much weight on the desktop. The motor cannot
lift up the desk or the lift mechanism may be stuck. Remove weight from
desktop. Check for and remove any obstacle that my be obstructing the desk
from lifting. If the problem persists, contact LifeSpan Customer Service.
Problem: "Table UART" appears in the display.
Solution: Check the connection of the console wire that goes into the
Electronic Control Box. It is most likely a loose connection.
If you experience any other error codes, please call LifeSpan Customer
Support.
33
Advertisement
Table of Contents
