Table of Contents
Advertisement
Power-assisted
steering oil level
STERN DRIVE VERSION ONLY
The tank mounted on the engine
allows to check the oil level of the
power steering.
1. Remove the plug, wipe clean
the dipstick.
2. Replace the plug and remove it
again.
3. Check that the oil level is be-
tween the Mini and Max mark. If
the level is too low, fill to a safe
operating level as indicated by
the dipstick. Do not exceed the
maximum level.
Use special fluid for power-assisted
steering or Dextron III automatic
transmission fluid. Replace the fill
cap and dipstick.
42
Stern Drive gear lube
CAUTION
Damage to the Stern drive
unit may occur due to lack of
lubrication.
If any water is visible at the
bottom of the gear lube monitor,
or if the gear lube appears disco-
lored, stop the engine except in
case of emergency, and contact
a Nanni workshop. It may indi-
cate a water leak in the Stern
drive unit.
Check the gear lube with the en-
gine cold, before starting.
1. Check the gear lube monitor
to determine the gear lube level.
The level should be between the
max. and min. marks.
2. Add gear lube if necessary. Re-
move the gear lube monitor cap
and add high performance gear
lube for Stern Drive.
Advertisement
Table of Contents
