Table of Contents
Advertisement
If the level is too low, remove the oil
filler plug and add oil slowly. Wait
few minutes before checking the oil
level to let the oil drain down to the
oil pan.
NOTICE: Completely drain the pre-
vious oil before adding new engine
oil. Never mix different type of oil.
Draining the engine oil
1. Start the engine and let it warm
few minutes so that oil suction is
easier.
2. Stop the engine and remove
the key from the panel.
3. Remove the cap of the drain
pipe
and connect the oil drain
pump.
4. Drain all the oil in the oil pan.
5. Disconnect the oil drain pump
and replace the cap on the drain
pipe.
41
Changing the oil filter
Change the oil filter each time the
engine oil is drained.
1. Remove the oil filter with a filter
wrench. Turn the filter counter-
clockwise. Remove the gasket.
2. Clean the mating surface in
order to prevent impurities from
entering the engine.
3. Apply a film of oil on the new
gasket. Screw the new filter by
hand with the new gasket. When
the gasket contacts the mating
surface, turn the filter a half turn.
4. Fill with correct amount of new
oil. Check for leaks and check the
oil level.
5. Start the engine and let it oper-
ate few minutes at idle. Check
that the oil pressure warning lamp
goes out.
6. Stop the engine, wait for the en-
gine to cool down and check the
oil level. Top up if necessary.
Advertisement
Table of Contents
