Nanni T4.205 Operator's Manual page 28

Panel with key
1. Move the control lever to the
neutral position.
2. Insert the key in the ON/STOP
starter switch.
3. Turn the key a quarter-turn to
the right. All the warning lamps
come on and the acoustic alarm
sounds. After a few seconds, only
the ENGINE OIL PRESSURE
and BATTERY CHARGE LAMPS
remain lit.
4. Press fully the START button to
start the engine. Once the engine
has started, release the button,
all lamps go out.
5. If the engine is fit with water
cooled exhaust elbow, check
that water flows from the exhaust
outlet at the hull. If the water does
not flow, stop the engine and
check the raw water system.

25
Panel without key
1. Switch the key of the main
panel to ignition (if equipped).
2. Move the control lever to the
neutral position.
3. Press the ON/STOP button. All
the warning lamps come on and
the acoustic alarm sounds. After
a few seconds, only the ENGINE
OIL PRESSURE and BATTERY
CHARGE LAMPS remain lit.
4. Press fully the START button to
start the engine. Once the engine
has started, release the button,
all lamps go out.
5. If the engine is fit with water
cooled exhaust elbow, check
that water flows from the exhaust
outlet at the hull. If the water does
not flow, stop the engine and
check the raw water system.