Operation; Before Starting - Nanni T4.205 Operator's Manual

Marine engine
Hide thumbs Also See for T4.205:
Table of Contents

Advertisement

O
6
PERATION

Before starting

WARNING
Put all the protective covers back
before starting the engine.
CAUTION
 Open the sea cock (if equip-
ped) before starting the engine.
The raw water pump impeller will
be damaged if it runs dry even
for few seconds, and may lead to
engine overheating.
Perform all of the following opera-
tions before starting the engine:
1. Open sea cock (if fitted). Prime
the raw water system if neces-
sary.
2. Start the compartment fan (if
fitted) for at least five minutes.
Otherwise, open the hold.
23
3. Check that there is sufficient
fuel.
4. Move the control lever to the
neutral position.
5. Open fuel cock, prime the sys-
tem if necessary.
6. Check the engine and trans-
mission oil level and fill with the
recommended oil if necessary.
7. Check the coolant level, top up
if necessary.
8. Check the control cables,
grease the connections if neces-
sary.
9. Check there are no fuel, oil,
coolant or water leaks.
10. Check the alternator belt.
11. Switch ON the main switch.
12. Lower the drive (Stern Drive
version only).

Advertisement

Table of Contents
loading

This manual is also suitable for:

T4.230T4.270

Table of Contents