Table of Contents
Advertisement
Operating the trim
system
ONLY IN STERN DRIVE VERSION
The trim system allows to adapt the
angle of the drive in relation to the
transom.
It also allows to lift the drive for
operation in shallow water or when
depth is uncertain. The position
of the drive is shown on the trim
indicator.
CAUTION
Modifying the boat trim will
affect its performance and its
behavior when cruising.
Avoid cruising at high speed
when the drive is raise to the
max in the trim range.
On twin engine installation,
the drives must be raise in the
lift range at the same time in the
beach or in the lift range.
The drive is protected against
corrosion by anodes and a
special paintwork. Make sure not
to damage the anode and check
their condition regularly.
The trim system is operated using
the trim control located at the
control position. It is generally inte-
grated to the control station.
28
NOTICE: The model of control
station and trim control can vary
according the boat. Informations
are given as an example. Control
station and trim control can be diffe-
rent.
When cruising, press the button
upward to raise the bow. Press the
button downwards to lower the bow.
Press the button
in the beach or in the lift range.
CAUTION
The max engine speed allowed
when the drive is in the beach
range is 1000 rpm.
to lift the drive
Advertisement
Table of Contents
