Remove The Upper Case; Touchpad) - Lenovo ThinkBook 15 Gen 2 Hardware Maintenance Manual

Figure 87. Detach the antenna cable connectors and disconnect the EDP cable form the system board
Step 4. Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove five screws and then remove the LCD module.
Figure 88. Remove five screws and remove the LCD module
Screw specifications
M2.5 x L5.5
Remove the upper case (with keyboard and touchpad)
Make sure the following FRUs (CRUs) have been removed.
"Remove the Bluetooth headset" on page 58
"Remove the lower case" on page 58
"Remove the battery pack" on page 59
"Remove the 2242 solid-state drive (SSD)" on page 60
80
Hardware Maintenance Manual
Number of screws
5