Remove The I/O Bracket (Right) - Lenovo ThinkBook 15 Gen 2 Hardware Maintenance Manual

Figure 65. Remove six screws and remove the I/O bracket (left)
Screw specifications
M2.0 x L4.0
Go to
https://support.lenovo.com/partslookup
part:
I/O bracket (left)

Remove the I/O bracket (right)

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 58
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove two screws and then remove the I/O bracket (right).
Figure 66. Remove two screws and remove the I/O bracket (right)
Screw specifications
M2.0 x L4.0
Number of screws
6
to look up the Lenovo part number of the following replacement
Number of screws
2
.
Chapter 4 Removing a FRU or CRU
69