Figure 58. Remove one screw and remove the Wi-Fi card by pulling it away from the slot
Screw specifications
M2.0 x L3.0
Go to
https://support.lenovo.com/partslookup
replacement parts:
Wi-Fi card
Mylar
Remove the heat sink
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 58
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove five screws and then remove the heat sink.
Figure 59. Remove five screws and remove the heat sink
Number of screws
1
to look up the Lenovo part numbers of the following
.
Chapter 4
Removing a FRU or CRU
65