Care And Cleaning - Gree Livo 4LIV09HP115V1AH Owner's Manual

CARE AND CLEANING

• Turn off the air conditioner and disconnect the
power before cleaning the air conditioner to avoid
electric shock.
• Do not wash the air conditioner with water to avoid
electric shock.
• Do not use volatile liquid to clean the air conditioner.
• Do not use liquid or corrosive detergent to clean the
appliance and do not splash water or other liquid
on it to avoid damaging the plastic components or
causing an electric shock.
Clean surface of indoor unit
When the surface of indoor unit is dirty, it is recomm
ended to use a soft dry cloth or wet cloth to wipe it.
NOTICE
• Do not remove the panel when cleaning it.
Clean filter
1. REMOVE FILTER
Press the spring fasteners at both sides in the direction
indicated by the arrows.
Meanwhile, lift up the filter so that it is separated from
the fasteners.
Pull the filter forward and remove it.
2. CLEAN FILTER
Use clean water to wash or a duster to clean it. If the
filter is very dirty (such as grease), clean with warm
water, do not dry in excessive heat.
3. INSTALL FILTER
After cleaning, reinstall the filter in reverse order. Push
it along the guide rails at both sides and then press the
left and right edges of the filter. Refit the filter in the
direction indicated by the arrows.
LIVO G EN4 OWNERS MANUA L - IND O OR UNIT
WARNING
• The filter should be cleaned every one – three
months. If there is lot of dust in the operation
environment, filter needs to be cleaned frequently.
• After removing the filter, do not touch fins to avoid
injury.
• To avoid deformation or a fire hazard, do not use
excessive heat when drying the filter.
NOTICE: Seasonal start-up tips
Make sure air inlets and air outlets are clear.
1.
Check to see the circuit breaker and wiring are in
2.
good condition.
Check if the filter is clean.
3.
Check mounting bracket for outdoor unit for damage
4.
and corrosion. If yes, please contact dealer.
Check to see the drain pipe is not damaged.
5.
NOTICE: Seasonal shut-down tips
Disconnect power supply.
1.
Clean filter and indoor unit's panel.
2.
Check the outdoor mounting bracket, have local
3.
contractor replace if damaged or corroded.
Recycle Please
Many packing materials are recyclable materials.
1.
Please dispose them in appropriate recycling bin.
If you want to dispose this unit, contact a local
2.
contractor or authority for assistance.
Error Code
When the system not working properly, the temperature
indicator on indoor unit will blink to display
corresponding error code. Please refer to below list for
identification of error code.
Error code
U8, H6, H3, E1,
E5, E6, E8
C5, F0, F1, F2
E7
E2, E9
NOTE
• If there're other error codes, please contact qualified professionals
for service.
| 18
WARNING
Troubleshooting
Try restarting the unit. If this does not
correct the problem contact a qualified HVAC
technician.
Please contact qualified professionals for
service.
Mode Conflict, please make sure all the indoor
units are running either on "COOL" or "HEAT"
mode in a multi-zone application.
These are not error code, they are operational
Status Code.