Summary of Contents for Assa Abloy Sargent AL-PE80 Series
Page 1
Installation Instructions AL-PE80 Series Alarmed Exit Devices WARNING WARNING This product can expose you to Attention Installer: Improper lead which is known to the state of installation may result in damage California to cause cancer and birth to the product and void the factory defects or other reproductive harm.
AL-PE80 Series Alarmed Exit Devices Installation Instructions General Description The SARGENT Alarmed Exit is designed for areas that require an alarm to sound upon exiting. Once armed, any push rail movement will activate the horn in the push rail. The horn will continue to sound for two minutes and then shut off automatically.
Page 4
AL-PE80 Series Alarmed Exit Devices Installation Instructions Door Preparation and Handing Verify hand and bevel of door. Exit devices are always reverse bevel and are mounted on the inside of the door. Left Hand Right Hand Reverse Bevel Reverse Bevel Hinges Left.
Page 5
AL-PE80 Series Alarmed Exit Devices Installation Instructions Cylinder Installation or Replacement (continued) Remove the original cylinder (or foam plug, if ordered without the cylinder): a. Remove the battery box to expose the rear side Cylinder (or foam plug) of the cylinder side. Use caution not to damage any wire or switch when opening the battery box as it is still connected to the assembly with the battery terminal wires.
Page 6
AL-PE80 Series Alarmed Exit Devices Installation Instructions Cylinder Installation or Replacement (continued) Connect the wire harness. Reinstall the battery box screws and the battery. Installation Instructions (for retrofit kit) Note: If an AL- prefix was ordered on a full device, refer to those instructions for the device installation. The following instructions are for alarm setup. ...
Page 7
AL-PE80 Series Alarmed Exit Devices Installation Instructions Installation Instructions (for retrofit kit, continued) a. Insert the trigger mechanism arms to the gap on both sides of the dogging cam (if present). Dogging slope b. Slide the trigger mechanism forward into the slot at the back of the dogging slope until it clicks into place.
AL-PE80 Series Alarmed Exit Devices Installation Instructions Alarmed Exit (AL-) Standard Operating Instructions To Arm Device Security / Tamper Violation Red LED Green LED Yellow LED Turn the key clockwise. The LED will flash yellow When ARMED, depressing the push rail will activate (PASSAGE) for 15 seconds (default).