Assa Abloy ACCENTRA 5300LN Grade 2 Installation Instructions Manual

5300LN Grade 2 or 4700LN Grade 1
Cylindrical Lever Locksets
Installation Instructions
IMPORTANT: The accuracy of the door preparation is critical for the proper functioning and security of this lever handle lock. Misalignment
can cause premature wear and tear and a lessening of security.
1. Parts
 2-1/8" (54mm) hole saw
 1" (26mm) boring bit
 5/16" (8mm) drill bit
 7/64" (2.5mm) drill bit
2. Installation
A. Mark Door
Mark horizontal line across edge of door for centerline of lock at desired
installation height. Fold template over edge of door, centering on
horizontal line. Mark centers of holes at proper backset.
NOTE: For beveled and square edge doors mark both sides of the door.
Be sure to verify backset before marking & drilling door.
B. Drill Door
1. Drill 2-1/8" (54mm) dia. hole thru the door. Cut notches as shown on
template. See note. (Except Dummy Trim)
2. Drill 1" (26mm) dia. hole in edge of door. Mortise for latch front
1-1/8" (29mm) wide x 2-1/4" (57mm) high x 5/32" (4mm) deep.
(Except Dummy Trim)
3. Drill two (2) 5/16" (8mm) dia. holes thru door. See note.
4. Drill pilot holes for latch screws. 7/64" (2.5mm) dia. (Except Dummy
Trim)
NOTE: To avoid splintering wood doors, drill holes (1) and (3) from both
sides of door.
WARNING
This product can expose you to lead which is known to the state of California to cause cancer and birth defects or other
reproductive harm. For more information go to www.P65warnings.ca.gov.
WARNING
Attention Installer: Any retrofi t or other fi eld modifi cation to a fi re rated opening can potentially impact the fi re rating of the
opening, and ASSA ABLOY makes no representations or warranties concerning what such impact may be in any specifi c
situation. When retrofi tting any portion of an existing fi re-rated opening, or specifying and installing a new fi re-rated opening,
please consult with a code specialist or local code offi cial (Authority Having Jurisdiction) to ensure compliance with all appli-
cable codes and ratings.
1-855-557-5078 Ext. 2 • www.accentra-assaabloy.com
Copyright © 2002, 2012, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved.
Reproduction in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is
prohibited.
Tools Required
 Chisel & hammer
 #2 Phillips screw driver
 Handle removal tool (supplied)
 3/8" or 1/2" drill
4
2
1
Door
Marker
3
80-9150-0060-010 04/24