Product Specific - Eneo INP-54M2812M0A Quick Installation Manual

Product specific

• The camera may never be pointed directly at the Sun with the aperture open (this will destroy the sensor)�
• It is unavoidable that during manufacture and to a certain extent during later use, humidity will be present in
the ambient air within the device's housing� In the event of large temperature fluctuations, this humidity may
condense inside the housing�
• To avoid this condensation inside the very tightly sealed housing, the manufacturer has inserted silica gel
sachets in the housing of the various camera types�
• It is however a physical given, that these silica gel bags will reach saturation after a certain amount of time� They
should therefore be replaced with new silica gel sachets�
• During installation, it is essential to ensure that the seals provided are correctly installed and that they are not
displaced during installation� Damaged seals must not be installed and will invalidate any warranty�
• A multipolar, easily accessible isolation device should be installed in the proximity of the IR Spotlight, in order to
disconnect the device from the power supply for service work�
• The earth connection must be made according to the low impedance requirement of DIN VDE 0100�
• Subsequent painting of the equipment surface can impair the function�
• Any warranty claim is invalidated by subsequent painting�
• A safety margin of > 1m from the spotlight must be maintained when viewing directly into the IR Spotlight in a
darkened environment�
• Do not look directly at invisible LED radiation using optical instruments (e�g� a reading glass, magnifying glass or
microscope), since this can endanger the eyes, LED Class 1M�
• Operation of the IR spotlight with a defective cover or during repair is prohibited�
EN
5