Installing the Touch Unit
Touch Unit Installation Location
The procedure differs depending on where the Touch Unit is installed.
: When installing the Touch Unit on the same surface as the projection surface, secure it using magnets
(built-in to the touch unit) or screws.
: When installing the Touch Unit on a different surface from the projection surface, secure it using the
Touch Unit Bracket.
When using the Touch Unit, images should be projected onto the front of the screen. You
cannot use finger touch operations when images are projected onto the rear of the screen.
Before installing the Touch Unit, make sure that the installation surface is not warped or
distorted, and that any unevenness on the screen surface is less than 5 mm.
Caution
88