Table of Contents
Advertisement
Installing the Wall mount
c
Determine the positions for the mounting holes for the wall plate
From the screw holes shown in the figure below, secure at least four points at the top, bottom, left,
and right for optimum balance.
d
Drill the holes in the wall
Drill diameter: 10.5 mm (M10) or 10 mm (3/8 inches)
Pilot hole depth: 45 mm
Anchor hole depth: 40 mm
c
When routing cables to the projector through a wall, you can drill holes within the area shown
in the figure below and use them as cable routing holes.
When installing a mini-PC or a stick PC, check the position at which the mini PC plate will be
installed before drilling cable routing holes. ( p.55)
e
Remove the template sheet
10.5mm (M10)
or
10mm (3/8 inch)
48
45mm
Advertisement
Table of Contents
