Choosing An Installation Location; Projector Installation Location; Control Pad Installation Location; Touch Unit Installation Location (Eb-1430Wi Only) - Epson EB-1430Wi Installation Manual

Using the Product Safely

Choosing an Installation Location

Projector installation location

• Carry out power supply wiring work for the installation location of the setting plate in advance.
• Install the projector away from other electric devices such as fluorescent lights or air conditioners. Some kinds of
fluorescent lights could interfere with the remote control of the projector.
• It is recommended to keep connection cable length less than 20 meters to reduce external noise.
• We recommend using stick-on screens or board screens.
• Make sure the projector is installed under the following conditions.
• The projected image is a rectangular shape without any distortion.
• The projector is tilted at an angle of no more than ±3° vertically and horizontally in relation to the screen.
• When using the interactive function (Easy Interactive Function), install so that the projected image is within reach.
• Do not install the projector or the screen in a location subject to direct sunlight. If the projector or the screen are
subject to direct sunlight, the interactive function may not operate correctly.

Control Pad installation location

When powering the Control Pad using batteries, make sure the installation location meets the following
requirements.
• Install the Control Pad on the same surface as the projection screen.
If the projection screen and the Control Pad installation point are uneven, install the Control Pad approximately 20
cm from the edge of the screen.
• Make sure there are no obstacles between the Control Pad and the projector (not including the Touch Unit).
In the following situations, use the optional Remote control cable set (ELPKC28) to supply power to the
Control Pad from the projector.
• When the requirements mentioned above are not met.
• When the projection screen and the Control Pad installation point are uneven and the difference in height is more
than 5 cm
• When the projector is placed on a table and projecting to the screen.
• When multiple projectors are being used.

Touch Unit installation location (EB-1430Wi only)

• When using the Touch Unit, install the projector using one of the following methods. The Touch Unit cannot be used
if another installation method is used.
• Mount the projector on a wall or suspend it from a ceiling and project images from in front of the screen.
• Install vertically on a table and project from the front of the table. (When installing vertically on a table, you need
the optional Interactive Table Mount (ELPMB29).)
• Before installing the Touch Unit, make sure that the installation location meets the following conditions.
• The Touch Unit can be secured with magnets or with screws.
• A flat, smooth, unwarped surface with no unevenness on the screen surface of more than 5 mm.
5