Introduction
Figures of Installation Dimensions
0 - 3mm
15 - 50mm
Caution
•
When installing the projector, make sure there is a gap between the wall and the projector's air exhaust and
intake vents. (See figure
•
When using the Touch Unit, make sure there is enough space around the projection screen. (See figure
above)
•
When installing the Touch Unit using the Touch Unit bracket, check the thickness of the frame around the
screen and the length from the installation surface to the screen surface. (See figure
c
Leaving a gap of approximately 100 mm from the ceiling to the top of the wall plate makes it easier
to install and remove the projector. (See figure
100mm
500mm
100mm
above)
14
46.5mm
16.4-50mm (EB-760Wi)
19.2-50mm (EB-770Fi)
46.4-50mm (EB-770Fi, 16:6)
38.1-50mm (EB-770Fi, 21:9)
20mm
above)
500mm
100mm
above)