Install The Mounting Base - Allen-Bradley D Series Installation Instructions Manual

Figure 1 - POINT I/O Input Module with 1734-TB or 1734-TBS Base
Description
1 Module locking mechanism
2 Slide-in writable label
3 Insertable I/O module
4 Removable terminal block (RTB) handle
5 Removable terminal block with screw (1734-RTB) or spring clamp (1734-RTBS)

Install the Mounting Base

To install the mounting base on the DIN rail (Allen-Bradley® part number 199-DR1; 46277-3; EN50022), proceed as follows:
WARNING: When used in a Class I, Division 2, hazardous location, this equipment must be mounted in a suitable enclosure with proper wiring method that
complies with the governing electrical codes.
1
10
9
7
8
Rockwell Automation Publication 1734-IN051L-EN-E - September 2022
POINT I/O Input Modules Installation Instructions
2
3
4
5
6
Description
6 1734-TB or 1734-TBS mounting base
7 Interlocking side pieces
8 Mechanical keying (orange)
9 DIN rail locking screw (orange)
10 Module wiring diagram
5