Husqvarna R 112C Operator's Manual page 26

3. Loosen and remove the blade bolt (B), the washers
(C) and the blade (D).
4. Assemble the new blade with the bent ends in the
direction of the cutting deck.
WARNING:
can cause objects to eject from the
cutting deck and cause serious injury.
Use only the blades given in
data on page 31 .
5. Attach the blade, the washer and the bolt. Tighten
the bolt with the correct tightening torque. Refer to
Technical data on page 31 .
To do a check of the engine oil level, (R
112C, R 112C5)
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole for the dipstick. Fill the oil
slowly.
Note:
Technical data on page 31 for the
See
types of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
26
Incorrect blade type
Technical
To do a check of the engine oil level, (R
115C)
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole for the dipstick. Fill the oil
slowly.
Note:
Technical data on page 31 for the
See
types of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
To replace the engine oil
WARNING:
directly after the engine stops. Let the
engine become cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
1. Put a container below the oil drain plug.
2. Remove the dipstick.
3. Remove the drain plug.
Engine oil is very hot
1466 - 006 - 17.04.2023