Husqvarna R 112C Operator's Manual page 15

a) If the engine is cold, put the throttle control in
position (C), choke position.
B
A
b) If the engine is warm, put the throttle control
between positions (A) and (B).
B
A
6. Turn the ignition key to the start position.
7. When the engine starts, immediately release the
ignition key to neutral position.
Note:
Do not run the starter for more than 5
seconds at a time. If the engine does not start, wait
15 seconds before you try again. Then if the engine
does not start, wait 1 minute before you try again.
8. Let the engine run at half throttle (B) for 3-5 minutes
before you apply heavy load.
9. Set the engine speed with the throttle control.
1466 - 006 - 17.04.2023
C
C
Note:
To engage the blades when the engine is at full
speed causes strain on the drive belts. Do not apply full
throttle until the cutting deck has been lowered to the
mow position.
To operate the product, R 112C, R
115C
1. Select cutting height (1–5) with the cutting height
lever.
2. Start the engine.
3. Press the parking brake pedal down and then
release it to disengage the parking brake.
4. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pressed
down. Use pedal (1) to move forward, and pedal (2)
to reverse.
5. Release the speed pedal to engage the brakes.
6. Lower the cutting deck.
1
2
15